Designing Kitchens and Bathrooms - Remove old fiberglass tub & walls, replace with another

HElp!

I just got quoted $2800 to remove my old, nasty fiberglass surround/insert & replace it with another. I have NO idea how to do this myself. I've seen the replacements at Home Depot for about $250.

How do I do this, and is it a big huge deal?

Thanks for any suggestions...

Rachel

It's not a big deal if you have some tools.

I use a rotozip to remove the old wall sections (ceramic and old surrounds) and take out the wall in one piece. (I think it's easier than tearing old tile down then the sheetrock) I take out only where the old surround or tiled area was.
You could use a jig saw or even a sawzall for this. I guess a hammer and flat pry bar would even work.
Once your down to bare studs, time to consider replacing the shower valve. You will never have a better opportunity.
Cut new greenboard or Durarock to size and screw in place (about every 6")
You do not need a precision fit around the shower stems at this time.
Put other panels up per instruction. Use a 1 3/8" drill bit for the shower stems when you install this panel.
Use an adhesive made just for surrounds, not a generic adhesive. Adhesives have chemicals that bleed through the panels and discolor them.
I will run 2x6 bull nose tile around surrounds to transition from the surround to sheetrock. Sometimes, I'll tile the entire area above the surround, depends on home owner.
Install new shower doors, and your done.

Have fun and take your time over a weekend. It will look great when your done and you will have a few bucks in your pocket.