Plumbing and Piping - Tub and shower diverter
Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.View Full Version : Tub and shower diverter
mtman
03-23-02, 11:14 AM
I just received a response from OLD GUY and I am grateful for his help . I was hoping that he could tell me how to replace the spout.
Thank You
MTMAN
Thank You
MTMAN
Mike Swearingen
03-23-02, 11:24 AM
mtman,
Please stay on the same thread on the same subject (it's easier for everyone to follow, especially when you're senile like me. LOL)
To replace a tub spout (no need to turn off water):
http://www.generich.com/customer/prodpics/web640e-640pb-m1.jpg
1. Check under the tub spout for a slot near the wall. If it has one, there may be a set-screw up in it that has to be loosened with an Allen wrench. If no slot, there probably is no set-screw.
2. Using a pipe wrench or channel-lock pliers (or maybe even your hands), unscrew the old spout off counter-clockwise.
3. The pipe with the threaded end sticking out of the wall should be 1/2". Wrap 2-3 flat turns of teflon tape clockwise only around the male threads.
4. Get a one-size-fits-all tub spout-with-diverter of your choosing, follow the directions that come with it to match what you're working with, and hand-tighten it onto the pipe.
5. Wrap a washcloth or towel around the new diverter to keep from marring it, and tighten it with the wrench or pliers against the wall.
That's all there is to it.
Good Luck!
Mike
Please stay on the same thread on the same subject (it's easier for everyone to follow, especially when you're senile like me. LOL)
To replace a tub spout (no need to turn off water):
http://www.generich.com/customer/prodpics/web640e-640pb-m1.jpg
1. Check under the tub spout for a slot near the wall. If it has one, there may be a set-screw up in it that has to be loosened with an Allen wrench. If no slot, there probably is no set-screw.
2. Using a pipe wrench or channel-lock pliers (or maybe even your hands), unscrew the old spout off counter-clockwise.
3. The pipe with the threaded end sticking out of the wall should be 1/2". Wrap 2-3 flat turns of teflon tape clockwise only around the male threads.
4. Get a one-size-fits-all tub spout-with-diverter of your choosing, follow the directions that come with it to match what you're working with, and hand-tighten it onto the pipe.
5. Wrap a washcloth or towel around the new diverter to keep from marring it, and tighten it with the wrench or pliers against the wall.
That's all there is to it.
Good Luck!
Mike