Entertainment Center: TVs, Stereos, VCRs and DVDs - zenith 56' tv convergenc promblems

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA
steve12345
02-25-02, 09:06 AM
hey i think i had a power surge and my tv went out so i replaced the power suply board and the tv came on but the picture had a 3-D afect so i went to the projo setup and tried to ajust the convergenc lines but they would not move .so i replaced the convergenc board and i still have the same prolem .please help modle# rz56z83d7

Smokey
02-25-02, 09:24 AM
Good Morning, steve12345:

From the symptoms you describe, I would recommend checking the B+ voltages to the convergence board. I would bet that the surge may have popped a fuse in the circuit or another supply is at fault.

Do you have a repair manual on this set?

Smokey ;)