Kitchen Gas Appliances - gas dryer -> flame sensor

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA

View Full Version : gas dryer -> flame sensor

07-23-01, 12:31 PM
Tom:

Thanks a lot.
You mentioned testing the flame sensor.
How does one do that?
Thanks again.

Hudson

Sharp Advice
07-23-01, 03:28 PM
Hello hribas

I went back and reread my reply. I neglected to mention checking for continuity. This can be done with a continuity tester or an ohm meter.

This test will tell only if there is an internal electrical connection. Best method is to carefully remove the part and any other part you suspect or I mentioned as the potential culprit, and have the local appliance parts store person run the test.

If you have additional questions or comments, use the reply button so the questions and replies will continue here in this thread. Makes it easier for everyone to follow along.

Thanks,
Tom