Outdoor Power Equipment and Small Engines - How to adjust carb on husqvarna chainsaw model 141

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA
DOUGCT55
11-05-09, 09:22 AM
PLEASE INSTRUCT ON HOW TO ADJUST THE CARB ON MY CHAIN SAW ,i REPAIRED IT AND THE ADJUSTMENT IS OFF. PLEASE TELL THE ORDER AND ADJUSTMENTS .THANK YOU

marbobj
11-05-09, 03:20 PM
Base settings are typically 1 1/2 turns out from lightly seated if you have the high and low adjustments screws.

What is your saw doing that's not quite right?
DOUGCT55
11-05-09, 05:16 PM
Saw was not running due to broken part of carb adaptor - pulse seal was broke .,carb was cleaned and now needs adjustment .,settings were lost .saw starts fine now but needs adj

Airman
11-06-09, 09:18 AM
Parts list for Husqvarna (Poulan) 141 shows a Walbro WT carburetor. These links should help.

http://wem.walbro.com/distributors/servicemanuals/WTseries.pdf

http://wem.walbro.com/distributors/servicemanuals/ServiceManual.pdf
gh0st
11-07-09, 06:42 AM
This might help http://forum.doityourself.com/outdoor-power-equipment-small-engines/262297-poulan-chainsaw-starts-but-wont-run.html
chainsaw-boy
11-08-09, 02:55 PM
put the screws (Both High and Low) all the way in. Then back them off about 1 turn each. After doing so start the saw make adjustments based on the sound of the saw. Adjust the idle as needed.