Fences and Gates - chain link fence gates
Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.View Full Version : chain link fence gates
prwcpa
10-19-09, 07:34 AM
I am getting ready to put up a chain link fence for the first time. I have not purchased any materials yet, but have one question before I begin. When placing posts, how far apart should they be for a gate opening to accomodate hinges and hardware....assume a 3' gate. I want to have my holes dug first and need to know how far apart to put the posts at each side of a 3' gate. I know that there will be some room needed to hang and latch the gate.
Thank You
Thank You
lefty
10-19-09, 09:36 AM
prwcpa,
Welcome to the forums.
The tape measure method is 3" wider than the gate.
The FOOLPROOF method is to set the hinge post first, hang the gate, and THEN set the latch post accordingly. Once you have that in, you can install the rest of the fence.
Welcome to the forums.
The tape measure method is 3" wider than the gate.
The FOOLPROOF method is to set the hinge post first, hang the gate, and THEN set the latch post accordingly. Once you have that in, you can install the rest of the fence.
vfence1
10-29-09, 10:44 AM
Well, before you start the work, it's important to check that the fence footings do not exceed legally established property lines. If uncertain, refer to real estate agent's line plot or consult a professional surveyor. Obtain necessary zoning and building permits. There may be local zoning or deed restrictions pertaining to height and type of fence.
GregsFence
11-02-09, 07:20 PM
Adding to the previous answers I would have to say that you should be aware of the different types of hinges, and latches that are available. The latch for the most part would should or would be a typical fork latch. For most fork latches you need a 2" allowance. If you are using a butterfly latch you may need a little more for the wing of the butterfly to clear the latch post on a swing. Butterfly latches typically have automatic closure. Sometimes used for pool enclosures, sometimes just as an option by choice.
In regards to hinges..
Most times the gate being 32 inches wide it is made to accommodate an opening of 36". 2 inches on the latch side, and 2 inches on the hinge side.
If you use pressed steel hinges you may lose about 1/2 inch. Using cast steel hinges you would need the full 2 inches allowance on the hinge side alone.
Much care in proper spacing goes into knowing which hinge and latch is going to be used.
Using the full proof way that lefty suggests sounds like your best bet . At least this way all your bases are coverred.
Good luck
Gregs Fence~
In regards to hinges..
Most times the gate being 32 inches wide it is made to accommodate an opening of 36". 2 inches on the latch side, and 2 inches on the hinge side.
If you use pressed steel hinges you may lose about 1/2 inch. Using cast steel hinges you would need the full 2 inches allowance on the hinge side alone.
Much care in proper spacing goes into knowing which hinge and latch is going to be used.
Using the full proof way that lefty suggests sounds like your best bet . At least this way all your bases are coverred.
Good luck
Gregs Fence~