Carpentry and Woodworking - Miter Cut

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA

View Full Version : Miter Cut

09-29-00, 04:24 PM
I am looking for the angle settings for a table saw, both the blade and the push guide to cut a crown moulding for both outside and inside cuts. I am assuming that you can lay the moulding on is back and make the cut with these angles set and it will come out right.

09-29-00, 08:57 PM
Search http://www.woodchuckcanuck.com for crown moulding. He has links to the exact information you seek (with graphics, of course).
10-14-00, 09:42 AM
The only angle you need is the push angle. usually 45 degrees. Lay the moulding on the saw the way it is installed and you have the other angle already. just cut.

10-14-00, 09:59 AM
All you need is the push bar angle (45degrees), lay the moulding on the saw the way it is installed. Leave the blade angle straight.
The moulding already has the angle.