Outdoor Power Equipment and Small Engines - kawasaki FC420V engine

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA

View Full Version : kawasaki FC420V engine

smenguy
06-07-09, 07:02 AM
Hi, I have a kawasaki FC420V engine OHV and there is a part that the nuts have come off of and it is now sticking out of the back of the motor. It is on the opposite side from the piston. Can I just put on new nuts and shove it back in? What torque would the nuts be? thanks for your help.

31YTech
06-07-09, 08:41 AM
If you are speaking of the balancer support shaft letter H, And the o-ring letter I is still in good condition just slide it back in and install new nuts (metric). There is no torque listed for these nuts other than general torque per screw/stud size.


http://i107.photobucket.com/albums/m314/Restrorob/Kawasaki/FC/FC420BalancerShaft.jpg



Good Luck
smenguy
06-07-09, 05:36 PM
yes that is the thing I was talking about. thanks very much for your help.