Electronic Alarms and Home Security Devices - PLEASE HELP DSC PowerSeries 9047 wiring horn to system

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA
AL-TIM
02-12-09, 10:06 AM
Hello all, I am new here and hope to get a little help from the members here. I just installed a DSC PowerSeries 9047 wireless system in my shop. Everything was going great until I wired a low voltage horn to the keypad. I have done a few wired systems before and you always wire the horn to the AUX + and -, but when I did this to this system and pop the keypad back in place the horn comes on and will not shut off. Any ideas????? PLEASE HELP:wall:

MrRonFL
02-12-09, 12:45 PM
Actually, that would be bell + and bell -, AUX +/- are continuous power.

In any case, this little all in one system doesn't _have_ a dedicated hardwire bell output. The best you could do is to program one of the PGM's to flip a relay to power a siren.
AL-TIM
02-13-09, 12:09 PM
tHANK YOU MrRonFL THAT WORKED. HAD TO MAKE INE OD THE I/O PORT DO IT