Carpentry and Woodworking - What type of router bit to replicate this edge (pic)

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA
mears
02-08-09, 02:09 PM
Any ideas?

https://www.msu.edu/~joshd/edge.jpg

Wirepuller38
02-09-09, 12:23 PM
I would suggest 3 passes using round over bits. The curve at the top looks to be a smaller radius than the 2 lower curves. Determine the radius of each curve and run some sample cuts until you find the correct size bits and depth of cut. Cut out some of the excess stock on a table saw before routing the 2 lower curves.