Electronic Alarms and Home Security Devices - power832 5501Z pc5010 Trouble Light

I changed a few settings in my alarm because I no longer want to be monitored.

The only things I did were:
- Removing bit 1 from [401] to prevent the alarm from answering my phone calls.
- Setting [371] to '9999' to disable the transmission test.
- Removing bit 7 from [015] to disable TLM (telephone line monitoring)

During this time, I made a few incorrect changes and have removed all power from the alarm a few times (causing me to reprogram the date and time).

I think I'm all done, but now I have a Trouble. [2] shows trouble 1. Pressing [1] to determine the specific trouble shows 5 which is listed as a "General System Supervisory" (the panel loses communication with any module connected to the Keybus).

Does anyone know how I can reset this trouble. I only have 1 keypad, 9 sensors including a smoke detector, and I haven't touched the wiring.

Thanks again for all,
Guy

Sorry again, I found a similar post in here that said to Enable Supervision [902] and [903]. My trouble light has gone out. I hope that's the last of my alarm woes.