Home Automation - XPS3 how to setup to be normally on (nc) ?
Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.View Full Version : XPS3 how to setup to be normally on (nc) ?
geoimpala
08-05-08, 07:24 AM
Hi
I have some XPS3 x10 switches and would like to control a blower electric motor with them.
The catch is that the control circuit will turn the motor on or off and the xp3 will be a secondary to this control. That means after a power outage or on startup of the system the XP# has to be in the on postion after power is restored ie (NC) until the switch is activated to switch off the power (perform function) then on again to permit the circuit controller to run the blower
Can an xp3 be setup to be on all the time - until tuned off rather than off all the time till turned on ?
thanks
I have some XPS3 x10 switches and would like to control a blower electric motor with them.
The catch is that the control circuit will turn the motor on or off and the xp3 will be a secondary to this control. That means after a power outage or on startup of the system the XP# has to be in the on postion after power is restored ie (NC) until the switch is activated to switch off the power (perform function) then on again to permit the circuit controller to run the blower
Can an xp3 be setup to be on all the time - until tuned off rather than off all the time till turned on ?
thanks