Carpentry and Woodworking - How to cut masonite paneling?

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA

View Full Version : How to cut masonite paneling?

pregnantchic
06-16-08, 02:13 PM
Trying to cut masonite paneling in 2x2 squares. Do not have a table saw and afraid masonite will rip or chip. Any suggestions on how to do this?

Wirepuller38
06-16-08, 03:59 PM
Use a circular saw with a fine-toothed blade. You will need a dust mask.
mango man
06-16-08, 04:01 PM
buy 2'x2' "handy panels " or have the lumberyard cut it for you

mikeTN
07-16-08, 02:23 PM
Fine toothed blade; cut from back side; use a clamped straight edge;set saw only slightly deeper than cut to be made.
gunrunnerjohn
07-19-08, 04:15 PM
You could also finish the edge with a router for a smooth finish.
PhillyGolfer
07-28-08, 12:05 PM
use a very fine blade in a jig saw. set up some sort of straight edge that is clamped to the masonite and use it as a fence to guide the jig saw. Putting some masking tape on both sides of where you want to cut may minimize tear out... as will using a utility knife to score the cut lines.