Outdoor Power Equipment and Small Engines - Briggs & Stratton 15HP OHV wiring

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA

View Full Version : Briggs & Stratton 15HP OHV wiring

mikeme
03-22-08, 08:49 AM
3/22/08

Hey Guys - HEEEEELP!!!

I have a 15HP OHV Briggs & Stratton - Electric Start - Model: 28N707 - Type: 016201 - Code: 9410214B. I'm installing it on a log splitter. My problem is that I can't figure out how to correctly wire it???? I just want a power on switch, a push button start, an amp charging gage and a regular old lawnmower battery. Will someone please send me a diagram that will solve my problem.

Thanks,
mikeme:wall:

31YTech
03-22-08, 03:41 PM
If you have a non regulated charging system it can be wired as below. There are four charging systems that could be on this engine.

If the carb has a fuel cut-off solenoid you would need a second toggle switch wired from the battery pos to switch then to the solenoid. Or you can use a standard mower switch in place of two toggles or remove the solenoid and snip the needle tip end close to the body with wire cutters then screw it back in.

When hooking to the stator make sure you use the wire with the diode just before the plug connector.


http://i107.photobucket.com/albums/m314/Restrorob/Briggs/BriggsPushButtonCircuit.jpg



Good Luck