Outdoor Power Equipment and Small Engines - generator wont run

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.




View Full Version : generator wont run


tecate87
02-03-08, 01:38 PM
coleman generator 6250 wont start. no spark, any common problems with these or where do I look first ??
:wall:


repair_guy
02-03-08, 04:28 PM
Since your problem sounds like it's more with the engine than with the generator And with the limited info that you supplyed I'd be afraid to guess. With engine brand & model,type or spec# we can help you better.

hopkinsr2
02-03-08, 04:56 PM
The pros will need the engine numbers to help you more, but 'till you get them, check the motor oil. Lots of generators have low oil kills. Also verify all the kills are turned on, important if this unit has remote start /stop controls. Maybe try a new plug to verify the "no spark" condition. Roger


tecate87
02-03-08, 05:14 PM
it has oil and full, only one switch for on/off.
tried different plug too.

the model number is PM0545007
briggs & straton engine, powermate 6250.

flirty1
02-03-08, 05:51 PM
remove the sparkplug and poor a teaspoon of gas into the sparkplug hole. re-install the plug and try cranking the engine. does it attempt to fire or run for a second or 2 before stopping. if so then its a carb problem. no attempt is made to fire then the coil might be bad. try and find a green wire coming from the coil remove it and see if it starts. if yes then the wire is grounded somewhere. if still no fire then the coil needs replacing

tecate87
02-07-08, 02:20 PM
it ended up being only the on/off switch. it must have had a bad connection. I tried it a dozen times it didnt work, had father-in-law try it worked after about 3 tries. thanks for all the replies.