Heat Pumps and Electric Heating - fan/heat sequencer help

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA

View Full Version : fan/heat sequencer help

mikeray
12-08-07, 09:42 AM
replaced sequencer on a coleman 3500 electric furnace with white-rodgers 24A34 it has 2 sequencers mounted on 1 steel plate just like the old one terminals m1 m2 m3 m4 m5 m6 my old one has only one jumper wire jumping the sequencers together the new one has two jumper wires one on each end should I leave the two jumper wires or clip one off to look like the old one thanks please help I have no responce from my other post

Jay11J
12-08-07, 06:38 PM
Does the install manual says anything about these jumpers?

I don't think I can pull anything up on line for Coleman.... I've never delt with Coleman other than gas furnace.