Outdoor Power Equipment and Small Engines - Need a carb adjustment tool for Ryobi CS30

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA
picksix
09-24-07, 10:00 AM
I'm looking for a tool that will fit the Idle misxture adjustment screws. The two screws are tucked into a narrow housing that makes it impossible to get a standard socket or even needle nose pliers in there.

hopkinsr2
09-24-07, 08:05 PM
I don't know what carb you have, but if it's a Warlbro, you can get the complete service kit from you're local Napa dealer for about $60 bucks. Make sure it has what you need, "cus I'm not sure what's in the kit. Roger
geogrubb
09-24-07, 08:24 PM
I have seen a post where you take a piece of 1/4 dowel stoch and drill a 9/64 hole in it and tap it over the adjustment screws or get a dremel tool and cut slots in them so you can use a screw driver. Have a good one. Geo