Electronic Alarms and Home Security Devices - dsc motion whit alarm zone 4 on always

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA
truffe98
09-01-07, 06:55 PM
i added a motion sensor dsc BV-300DP on my zone 4
also my zone are set to 04 interior or 05 interior stay/away
but my zone 4 on my keypad stay always on and i can't arm my system

when i remove zone 4 / function 202
everithing is ok
i have another motion sensor on zone 5 and i have no problem whit it

do you have some tip for me

tank's for all

kcxj
09-02-07, 01:10 PM
Did you install the EOL resistor?
truffe98
09-05-07, 10:16 AM
yes i install a 5.6k ohm resistor

MrRonFL
09-05-07, 04:23 PM
Assuming that you have supplied power to the device, and it seems to be reacting to motion, try this next: disconnect the alarm pair at the device end of the wire and twist them together (or simply put them under the same terminal) If the zone still doesn't close, then you either have a wiring issue, or a programming error.