Outdoor Power Equipment and Small Engines - Need Toro 7-25 rider wiring diaghram

I have an old toro 7-25 rider with a tecumseh TVM140 engine. I am threw pull starting it. The starter seems to work, at least when i tried it quickly on a battery. So I have a thick white wire to the starter, i have a black for the battery (-) and a thick red wire to go to the (+) terminal on battery i assume. But i have 2 wires that go to this clip that sits otop of the transmisiin case i believe (nuetral saftey??). And then there is aone remaining clip of 3 wires (a male connector) that should meet up with a female end. I am not sure what that one goes to nor do i know where the female end is?? i tried to find a wiring diag. but can't anywhere, i only have the engine model number and the 7-25 on the front sticker of the toro. but it's a 5 speed. and it's a solid state ignition. So i am curious how to hook up the wires so i charge the battery. i assume the three unconnected wires are the tings i need to fogure out. Any suggestions. I am extremly good with wiring, so just tell me what terminals on the keyswtich and where they go etc, and i can figure it out if you know where these wires should be roughly. thanks
keith