Electronic Alarms and Home Security Devices - DSC632 Programming Question

I have a alarm its Wired as Zone 1 & 2 Motions 3 4 5 are doors.

I think i need to disable zone 6 there are no resistors also. i would like the doors to be able to chime when i select chime on the keypad. the builder installed this and i ve ben messing with it for a while but the DSC manuals are horrible.
Can some one please advise on what to type in

Thank you

Read over the following thread: http://forum.doityourself.com/showthread.php?t=291653

His keystroke sequence for setting the zones is on the money. All you have to do is substitute the correct zone type for the correct zone number.

Use zone type 05 for the motions, and zone type 01 for the doors (which will make them all delay zones; use 03 if you want them to have no delay).

001 does not work in the manual it says to disable on enable zones secection [202] - [205] (whats the difference) but i dont know which and i think i might be doing it right but it says all zones are open what about the no resistor thing

If you are not using resistors, you need to turn on option 1 in programming section 013.

its a PC 1555MX if it matters

Ok so its almost working but i need to set up the zone delays the book says something about 202 -205 for zone here is what i want

Zone 1 05 Motion
Zone 2 05 Motion Be able to use the at home feature
Zone 3 01 Front Door Delay
Zone 4 03 Sliding door Instant
Zone 5 01 Back door delay

Whats next can someone show me how to prog at least one zone do i uses 202 or 205 or 001

*8
(installer)
.........

The power series panels are a rare instance where they did something rational, and all of the models (432, 632, 832, 864) use a common programming template for basic fuctions.

go to program: enter section 001

enter: 05 05 01 03 01 00 00 00

exit programming by pressing #

Normally, you don't need to mess with the settings in 202-205. Programming the unused zones as null in the zone type setting usually does the trick.

What section is this what zone does it do




go to program: enter section 001

enter: 05 05 01 03 01 00 00 00

exit programming by pressing #

nevermind
i got it now thanks

I cant get the Stay arm feature to work the 015 4 is enabled the away works fine but if i try and press stay it blanks out and if i put in my master code it goes in to programing and says 40

Check to make sure you didn't change any of the function key settings when you were working in the keypad programming section.

is there something i schould check because i think im going to have to do a default reset on it. if i cant figure it out

Hookay, First, if you altered keypad programming, defaulting the panel will not fix it, because the keypad programming has it's own default routine.

Try this: Go to program
enter 000 for keypad programming
enter 1 for programming function key #1
Enter 03 for stay arming
enter # until you are back in run mode.

If you have all the other stuff right, the function key should activate stay arming. Most likely you accidentally programmed the key for funtion 11 (*5 user programming command) when you were trying to set the keypad address.

If you _read_ the how to program instructions, in section 4.5 you will find clear instructions on how to view and interpret the contents of any programming section. That way you can verify that a location contains what you intended to program into it.

I never had to set the address of the keypad. also im wondering if im missing a manual or if there badly written i got three books 1 insturction and 2 installations

Ok thanks it will Arm now but nothing happens when the doors are opened?

The exit delay still runs, even in away arming. The doors won't trip an alarm until the exit delay runs out.