Kitchen Large Electric Appliances - Replacing Actuator in Kenmore Dryer

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA
2Bobcats
10-10-06, 04:08 PM
I have a Kenmore dryer Model 110.68942891 that was purchased in Oct. 1998. How do I get into the dryer to replace the actuator (part 691581)? I need specific instructions as to where to open and in what order (e.g., screws @ back, then brackets to release top, etc., etc.). Dryer is unplugged and ready for repair. This model has a bottom front panel and has the lint screen @ the front rather than on top.

dave6466
10-10-06, 07:28 PM
The part number you listed is the lever bracket for the door switch. Is that what you are refering to? If so, I believe you can pry up on the front corners of the top of machine, tilt the top up & get to the bracket reaching down in without taking anything else apart. Should be 2 long screws holding it in place.
2Bobcats
10-11-06, 09:29 AM
Thank you so much for the info; I'll give it a shot. BTW, the cabinet part listed in my Sears brochure is "Lever, Switch," but when I received the part, it was labelled "Actuator." Know I have the right part (whatever it is called) because the lever part of the one I am replacing is broken off and matches up to the new one. Yes, this is totally unknown territory for me! Thanks again.