Electronic Alarms and Home Security Devices - 5010 LED ON after program

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA

View Full Version : 5010 LED ON after program

ntran
06-03-06, 01:19 PM
Hi,

I have reset the panel to default and programmed as the follow instructions "from a thread".

After the program finished all LED lights are on and it's not in ready state.

I have checked at the panel all zones are 0V. "closed"

Please helps I am new to this.

Thanks in advance.
NT

=== Program sequence =======

Reset the panel to default "short Z1 to PGM1"
Set time and date "trouble light off"
press * + 8 + [installer code]
press 000
press 0
press 11
press # twice
press * + 8 + [installer code] + 902
press * + 8 + [installer code]
press 001
press 01 02 03 03 03 03 00 05
press # twice

All LEDS are on ???

MrRonFL
06-03-06, 04:31 PM
In programming, go to section 13, and turn on option 1. For whatever reason, a lot of installers don't use the end of line resistors on the DSC panels. On default the requirement is reactivated; this command turns off the resistor requirement.
ntran
06-03-06, 05:08 PM
Thanks MrRonFL !!!

That's all it needs.