Wallpaper and Wallcoverings - many layers!!!

I'm just trying to do some research for an upcoming job and thought this would be the best place to start. I don't have time to go through ALL posts, so forgive me for asking something that's likely already been asked. I'm going to be removing wallpaper in a bedroom, and the homeowner says there are approximately 5, yes, 5 layers. I know about DIF, detergent, etc., but are there any other good old fashioned tried and true methods out there?? Many thanks!

below is information found in the Sticky at the top of this topic. i think you should loosen a corner, pull, and see what happens. depending on what happens, follow the advice below.

========================================

How do I strip wallpaper?

The materials and techniques discussed, work on most types of wallpaper. Certain wallpapers require specialized techniques and may require professional assistance.

Wallpaper Stripping Technique

Start by stripping the outer face off of the wallpaper, sometimes this is a vinyl coating and other times, it is just a dense layer of paper. This should leave only the backing material and glue. Prepare a wallpaper stripping solution consisting of water and a little dishwashing detergent.

Wallpaper stripping solution should be sponged on the backing material and allowed to soak (re-wetting as necessary) for at least 10 minutes. A cheap garden-type sprayer will tremendously speed up the soaking process. Attempt to remove the backing material with a wallpaper scraping tool or alternately any flat bladed tool such as a wide putty knife. If this fails, re-wet the backing and allow to soak longer. The more you soak, the easier the job.

If the above stripping solution is not working well enough, you may also try a solution of 2 parts water to 1 part white vinegar and use the same technique. This stripping solution is only effective against wallpaper installed using wheat or starch based wallpaper adhesives. If the adhesive is unknown, use a generic stripper product.

If you have really stubborn wallpaper, obtain some Safe and Simple online http://www.safeandsimple.com from your local home improvement store, and follow the bottle's directions to remove the remaining backing material.

If you plan on painting the area you just stripped, you must ensure that all the glue behind the backing is removed. To tell if there is still glue remaining, wet the wall and feel it. Any slimy areas mean there is glue left over.

To remove any remaining glue, mix 2 tablespoons of liquid fabric softener into a gallon of water and scrub. You must also carefully rinse the entire wall surface so there are no traces of paste or wallpaper stripper remaining behind, before you paint.

If your vinyl/dense paper facing does not want to peel off the backing, you may try to dry peel it off the wall which may or may not cause wall damage. Paper scoring tools can damage the drywall underneath the wallpaper, but are gentler on plaster walls.

Ensure you read the directions on the package for complete instructions, but a good rule of thumb is to let the tool do the work. Additional lateral pressure will cause undo damage to the wall surface. An alternate method is to use a razor to score a series of Xs into the wallpaper surface. This requires a careful touch as to not damage the underlying wall surface.

In some cases, the scoring and soaking steps will promote or enhance the stripping of the facing material, so after this step, attempt to removing the facing material again. If still no success, you will have to perform repetitive score, soak, and strip steps to remove your wallpaper.

"I'm just trying to do some research for an upcoming job "

Test drive an area before pricing it out so you can have an idea of how it will come off.