heat pump wiring,thermostat burns up transformer

[GORACING57]

Hello,I just purchased a Goodman 3 1/2 ton heatpump(CPLJ42-1) and airhandler(AR(UF)49-1) with 10kw heatstrips for emergency heat.I also purchased a honeywell model T8001C thermostat.I purchased this on ebay as new but no instructions. http://www.honeywell.com.au/business/acs/acp/ecc/manuals/T8000C_T8001C__T8011.pdf
The connection letters are:
G,C,R,W,Y,B and O
Also,there is a switch on back with the letters E and F on back and Im unsure what these do and what to set it on.
I wired up the thermostat and heatpump/airhandler with the specs provided (page 13 top schematic)(no outside thermostats) http://www.alpinehomeair.com/related/Goodman%20Heat%20Pump%20-%20Install%20and%20Operating%20Inst.pdf

My problem is the air worked fine but when I tried the heat it burned up my 24vt transformer.I tried rewiring it and again it toasted another transformer.
Should I have used the bottom schematic on page 13(it shows a EHR(emergency heat relay)?My airhandler didnt have a EHR but it did have a brown wire as shown coming from the airhandler connections.I was told to tie the brown and white together from the airhandler connections.



I need help,I cant afford to keep buying transformers......Thankssssssssss. :wall:

[lenny56769]

well if iam right you have a package unit heatpump with 10k heat strip well the heat strip is the ehr but iam not going to down load all the pages from the links you have if you care to send just the pages to me i need ill look at it but i can tell you brw is most of time heat if wired right