Lighting, Light Fixtures, Ceiling and Exhaust Fans - outlet to light switch

I replaced an outlet that is attached to the light switch. I did not pay attention to how it was wired before and I do not have the outlet that was there. I have 2 sets of wires all of which have a white red and black. They all lead to 2 white wires, 1 black and 1 red. I have attached the white to the left silver bracket side and the red and black to the right gold side. I have broken the gold tab between the 2 gold side and connected the grounder wire, but the switch does not work. I did 4 others like this which work fine, but they did not have a red wire on each set to begin with. Do I have to break the tab on the left between the white wires on the silver side also.Any advise?

This question is begin adequately addressed over in the Electrical forum, so I'm going to close this thread to avoid duplication. If you want to see or contribute to that thread, go here (http://forum.doityourself.com/showthread.php?t=221232).