Kenmore Washer

[markbrown47]

I have a Kenmore washer 70 Series. It started leaking water. Not the hoses or discharge line. How do I get into the cabinet to check out pump and hoses that are inside that I can't see from the outside?

Mark Brown

[unhandyman dave]

There are two screws underneath the dials. Unscrew them and flip the
dial panel up. On each side there are two clips. You have to push on them
to make them unsnap. I hope this helps.
Dave

[bambiblaster]

COMMON LEAK IS THE PUMP... YOU CAN ALSO TIP MACHINE BACK TO LOOK UNDER... MOST LIKELY SEE A RUST CLIP THAT HOLDS PUMP ON... AS SAID BEFORE TAKE OUT 2 CONSOLE SCREWS... FLIP CONSOLE BACK...UNPLUG LID SWITCH CONNECTOR AND TAKE OFF THE 2 CLAMPS AND YA GOT IT ALL IN FRONT OF YA... GOOD LUCK :coffee: