Electronic Alarms and Home Security Devices - Aurora motion
Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.View Full Version : Aurora motion
kn195
04-06-05, 07:55 PM
Hello
I just installed Vista-20P , 6160v , and Aurora motion detector which is hardwired, 4 wired, I wired it as follow:
(+) to Aux + on the pannel, (-) to (-) on the pannel, the other 2 wired says RR, which I connected to H/L on the zone " zone 8 ", Also I put EOL 2000 OHM between the H/L. I powered up the keypad, it display " Fault 08 " , what did I do wrong and how I fix it?
Thanks
I just installed Vista-20P , 6160v , and Aurora motion detector which is hardwired, 4 wired, I wired it as follow:
(+) to Aux + on the pannel, (-) to (-) on the pannel, the other 2 wired says RR, which I connected to H/L on the zone " zone 8 ", Also I put EOL 2000 OHM between the H/L. I powered up the keypad, it display " Fault 08 " , what did I do wrong and how I fix it?
Thanks
MrRonFL
04-07-05, 05:27 AM
The resistor needs to be in series with one of the zone wires, not in parallel, as you have it. You also need to set the zone in the system program if it's not already set for an interior type zone.
kn195
04-08-05, 04:55 PM
Thanks a lot, it works.