Maytag dshwshr,checked door latch etc

[ifihadadime]

undefinedI have a Maytag dishwasher @2 years old. It appears to have stopped in the middle of a cycle judging by the water left in the bottom. The control panel will not respond to any touches. :eek: I checked the door latch and the manf installed locking option is off, I checked the outlet with a voltage tester & it is fine. I also checked the outside breaker which is fine. I am assuming that there is a kill switch or a fuse on the d/w. If so can anyone tell me where it is. Or offer any other advise? Please help!

[MLINEBERGER]

need model number for better service but it does sound like the control board if you do have power coming OUT of the door switch to the panel. have seen moisture get into the panel and kill it. remove the inner panel ( after you have killed the power) check upper left corner or where ever the hot air is released to see if that is clear. some models have a wax motor that opens up to vent the air. if that has failed, then you might need that as well. look at your diagram and if you able to do LIVE checks, then it is pretty simple. Verify that you have 120 volts coming into the board. if not, your problem could lie elsewhere. give it a shot!