Outdoor Power Equipment and Small Engines - Flywheel removal and installation HELP for a Briggs & Stratton 12 HP

Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.



PDA
Eddiemann
07-04-04, 12:59 PM
Could someone please tell me how to remove a Plastic Ring Gear off the flywheel?

Thank You:
Eddiemann

sceptre
07-04-04, 11:56 PM
first take the flywheel off the engine. then use a small center punch to make a indention in the four pins on the fin side. use a 1/8 drill bit make a hole about 1/8 inch deep. change bit to 1/4 drill bit then drill till the brad end is removed. use a 3/16 pin punch to drive out the pins. install the new replacement ring gear according to instructions. the new gear will be aluminum, it should last the remainder of the engine's life. i've replaced several of these and this is how i do it.

later,