Furniture, Wood and Cabinetry Finishing - trim board
Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.View Full Version : trim board
sharpa
06-22-04, 01:57 PM
How do I mitre a trim board that meets each other at a 135 degree angle? I need 2 mitres of 67.5 degrees each but my mitre saw only goes to 55 degrees?
chfite
06-22-04, 02:20 PM
Miter off 22.5 degrees. Make a piece with a 45 degree miter and use it as a guide clamped to your table to hold the piece to remove a piece 22.5 degrees.
If this is an inside corner, just cope the joint and it will fit everytime, anyway.
Hope this helps.
If this is an inside corner, just cope the joint and it will fit everytime, anyway.
Hope this helps.