Gas and Oil Home Heating Furnaces - bryant furnace

i have a bryant gas furnace witch has a led light at bottom, well my furnace will start up run fine until warm, then turn of, when it calls for heat again the blower will come on then the burners will come on but then turn of. it will try three more times before lock out. and will not turn on until three hours later???? what is wrong ??:( :confused:

Are you on LP Gas? If so, do you have a full tank of gas?

Count how many fast & slow flashes- that is the code form what is failing

I have a similar problem with my Bryant furnace - the LED code that I'm getting is 14. If I shut the power off to the unit, turn gas off for a few minutes just to be safe, and then turn it back on it will fire up, but after one cycle it stops. Any help?

Originally posted by DMD42bluz
I have a similar problem with my Bryant furnace - the LED code that I'm getting is 14. If I shut the power off to the unit, turn gas off for a few minutes just to be safe, and then turn it back on it will fire up, but after one cycle it stops. Any help?

Your problem is most likely the flame sensor.
On the left side in front of the left burner you will see a wire
about as thick as a wire coat hanger.
Try cleaning it with some steelwool.
Depneding on how old yours is - Byant has an upgraded
flame sensor, which helps eliminate this problem.

Also look inside the burners- I've had some get lint build up
inside & block the star openings which distribute the flame
properly

what does the wiring diagram say code 14 means?