Entertainment Center: TVs, Stereos, VCRs and DVDs - Toshiba 55 red power light blinking
Doityourself.com community forum was created to provide answers to all questions related to home improvement and home repair. Doityourself community can help you find information about how-to topics on small fixes to large remodeling projects. With comprehensive how-to content and expertly moderated community forums DoItYourself.com makes it easy to tackle even the most complex home improvement projects.View Full Version : Toshiba 55 red power light blinking
acedish
11-20-02, 12:34 PM
hello, I have read a few other posts regarding this situation but i am still unclear which part is defective or how to check.
Symptom: red light blinks beside power button (No pic or sound)
Model: TP50F60
All fusess are good, i have found that if i unplug the 6 pin connector going to the (convergence control module?) to the red bulb control the TV will work and the display from the red bulb is out of whack, but it does light up. The other 2 bulbs display are fine. So my question is do i replace that control module or is it the red bulb problem or what?
Thanks, Costa
Symptom: red light blinks beside power button (No pic or sound)
Model: TP50F60
All fusess are good, i have found that if i unplug the 6 pin connector going to the (convergence control module?) to the red bulb control the TV will work and the display from the red bulb is out of whack, but it does light up. The other 2 bulbs display are fine. So my question is do i replace that control module or is it the red bulb problem or what?
Thanks, Costa
FREDDYG_001
11-25-02, 09:06 PM
Tech Tip as follows:
1)Dead, Power Led Blinks./Remove connector p807 and set came on. Replace reg's. convergence board. #Stk392-110
Common Problem!
Fred:)
1)Dead, Power Led Blinks./Remove connector p807 and set came on. Replace reg's. convergence board. #Stk392-110
Common Problem!
Fred:)
acedish
02-26-03, 02:10 PM
I ordered part number STK392-110 and finally got around to replacing and once a pulled the Board out I noticed there are 2 STK392-110 looks like one is for Verticle and one for Horizontal? I only ordered one do i need to replace both if not which oneany way to test.