| I rechecked voltage and got 120 to ground at each wire going in to the motor, then I ran the motor on 120 external power supply and it ran fine. Today i pulled the control board and there was a smoky area on the wall behind it. It looks like the smaller relay on the board popped and burned part of the solder trace next to it. I'm concered though because i want to make sure that the relay isn't just an effect of another fault in the unit. Is there any way i can check for that. Also does anyone know how to get a replacement gasket for the inducer motor. When i took the fan off, the gasket fell apart. I've googled everything that i know how to and cannot find a way to get a gasket without buying a whole motor. |