Quote:
Originally Posted by jsouth  I took the carb. off 3 times and look at the throttle,the trigger looks fine,no binding.The saw does not die,at all,it will start on the fist pull.When I squeeze the trigger the saw will run faster,but when I let off the trigger the chain will not stop.Could it have a bad clutch,it so I do you check for that.
Thanks,
Jerry |
now you're describing a different problem. is the saw not able to idle or is the chain moving at idle ? a high setting on the low mix screw and the idle stop will cause the chain to move but will allow the engine to rev up to operating speed. week clutch springs will allow the chain to creep and or move but is not very common. is the clutch intact ?